To Next PageTo Next Page
Need help?Do you have a question about the Fisher Scientific 650 Series and is the answer not in the manual?
General| Brand | Fisher Scientific |
|---|---|
| Model | 650 Series |
| Category | Laboratory Equipment |
| Language | English |
Definitions for Warning, Caution, and Note alerts regarding personal injury or equipment damage.
Guidance on choosing a suitable and safe location for furnace installation.
Instructions for carefully unpacking the furnace and verifying contents.
Steps for preparing the muffle furnace for operation, including packing removal and hearth plate placement.
Description of the LED numeric displays and indicator LEDs for furnace status.
Details the functions of the keypad buttons.
Description of the power switch and function of the circulating fan.
How to set and maintain a constant temperature using the furnace.
How the furnace executes temperature cycles with programmed ramps and soaks.
Explanation of Set Point (SP), Soak, and Jump Loop steps for programming temperature cycles.
Step-by-step guide to constructing a custom temperature program.
Instructions for starting, pausing, and restarting a programmed temperature cycle.
How to monitor the progress and parameters of a running ramp and soak program.
Defines parameters displayed during program operation like End Set Point, Rate, and Soak time.
An example ramp and soak program based on an ASTM method.
Explanation of the high temperature alarm function and activation conditions.
Indicates an open thermocouple fault and troubleshooting steps.
Procedure for calibrating the furnace temperature using a reference thermometer.
How to set and switch between Celsius (°C) and Fahrenheit (°F) display units.
Options for furnace behavior upon power restoration in ramp/soak mode.
Setup parameters for logging data via serial communication.
Instructions for establishing serial communication with a PC for data logging.
Step-by-step instructions for safely replacing a defective heating element.
Detailed procedure for replacing the furnace's control thermocouple.
Instructions for replacing the solid state relay that cycles power to the heaters.
Procedure for replacing the magnetic relay that disconnects heater power during alarms or door opening.
