What to do if there is no display on the screen of Fisher Scientific Laboratory Equipment?
If the Fisher Scientific Laboratory Equipment displays no image on the screen, first, check the main voltage and ensure the unit's voltage matches the power supply. Next, verify the unit is properly plugged in and replace any blown fuses. If the issue continues, the display screen might be faulty, and you should contact technical support.
Why is the fan not working in my Fisher Scientific Bead Mill 24?
If the fan in your Fisher Scientific Laboratory Equipment is not working, begin by checking the main voltage to ensure it is correct. Confirm that the unit's voltage matches the main power supply. Ensure the equipment is properly plugged in and replace any blown fuses. If the fan still doesn't work, it may be faulty, requiring you to turn off the unit and contact technical support.
How to close the unclosed lid of Fisher Scientific Laboratory Equipment?
If the lid of your Fisher Scientific Laboratory Equipment won't close, first ensure nothing is obstructing it. Press the lid down to make sure the handle locks properly. If it still doesn't close, the detection system may be faulty. Turn off the unit and contact technical assistance.
What to do if Fisher Scientific Bead Mill 24 Laboratory Equipment powers on with a loud bang?
If the Fisher Scientific Laboratory Equipment powers on with a loud “BANG”, this indicates that the motor control device has been damaged due to incorrect voltage selection. Return the unit to Fisher Scientific for a replacement of the motor control device.
What to do if Fisher Scientific Laboratory Equipment powers on but motor does not turn?
If your Fisher Scientific Laboratory Equipment powers on but the motor doesn't turn, the voltage selected may be incorrect. Power off the unit and select the appropriate voltage. If the problem persists, contact Fisher Scientific for assistance.
How to fix the display screen showing unusual characters on Fisher Scientific Bead Mill 24 Laboratory Equipment?
To address incomplete or unusual characters on the display screen of your Fisher Scientific Laboratory Equipment, turn off the unit, wait 10 seconds, and then turn it back on. This will reset the CPU.
Why is there tube leakage in my Fisher Scientific Bead Mill 24 Laboratory Equipment?
If you are experiencing tube leakage with your Fisher Scientific Laboratory Equipment, it may be caused by the speed being too high or high temperature or pressure inside tubes. Try reducing the processing time or speed.
What to do if one or several tubes are not sealed tightly in Fisher Scientific Bead Mill 24 Laboratory Equipment?
If one or several tubes are not sealed tightly in your Fisher Scientific Laboratory Equipment, it could be due to the cap not being properly sealed or the tube being faulty. If the tube contains a dangerous or potentially dangerous sample, apply the appropriate decontamination procedure.
How to disengage a difficult fingerplate lock on Fisher Scientific Bead Mill 24?
To disengage a fingerplate lock that is difficult to move on your Fisher Scientific Laboratory Equipment, turn the knob slightly counter-clockwise to release tension.
Identifies key physical parts of the Bead Mill 24, including lid, drive hub, and keypad.
Guidance on changing user interface language and navigating programming modes.
General| Brand | Fisher Scientific |
|---|---|
| Model | Bead Mill 24 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page