34
Relic-Hunting and Coin-Shooting
with the Optional 11” DD Searchcoil
While the Gold Bug
®
is a high performance, specialized gold prospecting metal
detector, it is also a good multi-purpose detector. With the purchase of an 11”
DD searchcoil, you can bring more power to your coin-shooting and relic-
hunting searches.
The standard 5” Gold Bug
®
searchcoil is engineered for precision and is best at
finding the smallest gold nuggets that most other gold prospecting detectors
would miss.
If you want a larger sweep area and deeper detection, the 11” DD should be
considered.
Advantages of the 11” DD searchcoil are:
1. Deeper detection
2. Broader sweep (cover more area in less time)
For information about the 11”DD searchcoil
(Part# 11COIL-GB, MSRP=$199.95),
Please call 800-685-5050.
ASSEMBLY
Assembly is easy and
requires no tools.
●
1 Position S-Rod upright.
●
2 Rotate the LOCKING
COLLAR fully in
the
counterclockwise
direction.
●
3 Insert your finger
inside the tube and
make sure the INTERNAL CAM LOCK is flush with the
inside of the tube.
●
4
Insert the MIDDLE STEM into the S-ROD,
with the SILVER BUTTON pointed upward
●
5 Rotate the MIDDLE STEM until the SILVER BUTTON
locates in the hole.
●
6 Twist the LOCKING COLLAR fully in the clockwise direction
until it locks.
●
7 Repeat this process on the LOWER STEM.
●
8 Using the BOLT and KNURLED KNOB, attach the
SEARCHCOIL to the LOWER STEM.
●
9
Adjust the LOWER STEM to a length that lets you maintain a
comfortable upright posture, with your arm relaxed at your side,
and the SEARCHCOIL parallel to the ground in front of you.
●
10
Wind the CABLE securely around the STEMS, leaving slack at
the bottom.
●
11
Connect CABLE PLUG to housing.
Do not twist the Cable or Plug. Turn Locking Ring only. Use
minimal finger pressure to start the threads. Do not cross-
thread. When the Locking Ring is fully engaged over the
threaded connector, give it a firm turn to make sure that it is
very tight. When the Locking Ring is fully engaged over the
threaded connector, it may not cover all of the threads.
●
12
Tighten both LOCKING COLLARS.
●
2
●
3
●
4
*
Note: Very tall users can purchase the optional Extended
Lower Stem (TUBE5X), for extended reach.
Caution:
Forcing in MIDDLE STEM with CAM
LOCK raised may form a burr on
camlock. If this happens, remove
burr with knife to allow insertion.
To Next Page
Loading...
Need help?
General
