EasyManuals Logo

Fisher M-Scope CZ-5 Quicksilver User Manual

Fisher M-Scope CZ-5 Quicksilver
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
18
Figure 6. Keep the search coil
parallel and close to the
ground at all times.
SEARCHING
9. Keep the search coil moving at a comfortable rate.
Remember that the CZ-5 is a motion detector and
responds only when the coil (or the target) is moving
(except in the Pinpoint mode).
10. Take your time. If you walk too fast you can’t
overlap your sweeps and you’ll miss a lot of ground.
If you swing your coil too fast you lose some
sensitivity to deep and/or small targets.
11. Figure 7 on the next page shows the CZ-5 search
coil pattern and how it is affected by sweep speed,
ground mineralization and search mode.
Figure 5. Search pattern.
When the stem length is properly
adjusted, the CZ-5 is balanced for
sweeping in a tight semicircle. Wide
to the right for right handers. Wide
to the left for left handers.
Be sure to overlap your sweeps.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fisher M-Scope CZ-5 Quicksilver and is the answer not in the manual?

Fisher M-Scope CZ-5 Quicksilver Specifications

General IconGeneral
BrandFisher
ModelM-Scope CZ-5 Quicksilver
CategoryMetal Detector
LanguageEnglish

Related product manuals