2
Quick start
Power – Install a 9V alkaline or lithium battery (not included).
Set the controls – Volume at minimum, select at #1 and blend at
its mid-point.
Plug in – Use standard ¼-inch shielded instrument cables. Place any other
pedals after the Aura.
Set trim – Play hard and adjust input trim (right side) so clip/batt LED fl ashes
occasionally.
Select an Image – Raise the volume and audition the 16 Images with the
select knob.
Blend to taste – turn left for more pickup and right for more Image.
Kill feedback – If feedback starts, change the position of the phase switch.
Bypass – Step on the footswitch to alternate between blended Image sound
and dry pickup (default setting).
Mute – To alternate between blended Image sound and mute, hold the
footswitch down until the LED fl ashes. Repeat to return to bypass.
To Next Page
Loading...
