10
Controls (continued)
4. Anti-Feedback
The Ellipse Aura is equipped with an automatic search-and-destroy notch filter.
To engage the feature, turn the Volume down and move the Anti-Feedback
switch left (On position). Hold the Measure button for a few seconds. The Battery
LED will begin to flash. Turn up the Volume, then either dampen the strings while
tapping the body or play the troublesome note until feedback begins. The filter
will latch onto the feedback, eliminate it after a few seconds and hold the setting
in memory until you push the Measure button again.
If you plan to record with the Ellipse Aura, we recommend you turn off the
Anti-Feedback to fill out the natural low-end response of the guitar.
To Next Page
Loading...
Need help?
General
