Flaem 4Neb - Device Information and Disposal; Understanding Device Symbols; Device Disposal and Environmental Compliance

SYMBOLS
CE Medical Marking ref.
Dir. 93/42 EEC and subsequent
amendments
Serial number of device
Class II device Manufacturer
Important: check the operating
instructions
Type BF applied part
Switch
“ON”
When you shut o the
device, the switch will
interrupt the com-
pressor function only
on one of the two
power phases
Alternating current
Switch
“OFF”
Minimum and maximum room
temperature
Minimum and maximum
atmospheric pressure
Minimum and maximum air moisture
Complies with: European
standard EN 10993-1 “Biological
Evaluation of Medical Devices”
and European Directive 93/42/
EEC “Medical Devices”. Phthalates
free. In conformity with Reg. (EC)
no. 1907/2006
IP21
Enclosure protection rating: IP21.
(Protected against solid bodies over
12 mm. Protected against access
with a nger;
Protected against vertically falling
water drops).
ELECTROMAGNETIC COMPATIBILITY
This device was designed to satisfy the currently required requisites for
electromagnetic compatibility (EN 60601-1-2). Electro-medical devices require
particular care during installation and use relative to EMC requirements. Users are
therefore requested to install and/or use these devices following the manufacturer's
specications. There is a risk of potential electromagnetic interference with other
devices. RF mobile or portable radio and telecommunications devices (mobile
telephones or wireless connections) can interfere with the functioning of electro-
medical devices. For further information visit our website www.aemnuova.it. The
Medical Device may be subject to electromagnetic interference if other devices are
used for specic diagnosis or treatments. Flaem reserves the right to make technical
and functional modications to the product with no prior warning.
DISPOSAL OF DEVICE:
In conformity with Directive 2012/19/EC, the symbol shown on the device to
be disposed of indicates that it is considered as waste and is therefore subject
to “sorted waste collection”. The user must therefore take (or have taken)
the above waste to a pre-sorted waste collection centre set up by the local
authorities, or else give it back to the dealer when purchasing a new appliance of the
same type. Pre-sorted waste collection and the subsequent treatment, recovery and
disposal operations favor the production of appliances made of recycled materials
and Iimit the negative eects of any incorrect waste management on the environment
and public health. The unlawful disposal of the product by the user could result in
administrative nes as provided by the laws transposing Directive 2012/19/EC of the
European member state or of the Country in which the product is disposed of.
8
9