Flaem 4Neb - Air Filter and Disinfection Methods; Air Filter Maintenance and Replacement; Disinfection Procedures

The disinfectant must be an electrolytic chloroxidizer (active principle: sodium hy-
pochlorite) specic for disinfecting, which is available in any pharmacy.
Implementation:
- Fill a container big enough to hold all of the parts to disinfect with a solution of
potable water and disinfectant, according to the proportions indicated on the
packaging of the disinfectant.
- Completely immerse each part in the solution, taking care to avoid the formation
of air bubbles on the parts. Leave the parts immersed for the amount of time in-
dicated on the packaging of the disinfectant associated with the concentration
chosen for the solution.
- Remove the disinfected parts and rinse abundantly with warm potable water.
- Dispose of the solution following the instructions provided by the disinfectant
manufacturer.
method B: sanitise the accessories C1.1-C1.1a-C1.1b-C1.1c-C1.2-C1.3-C1.4-C2-C3-
C4 by boiling them in water for 10 minutes; use demineralised or distilled water to
prevent calcium deposits.
method C: sanitise the accessories C1.1-C1.1a-C1.1b-C1.1c-C1.2-C1.3-C1.4-C2-C3-
C4 with a hot steam steriliser for baby-bottle (not the microwave type). Perform the
process faithfully following the instructions of the steriliser. To ensure that the disin-
fection is eective, choose a steriliser with an operating cycle of at least 6 minutes.
After having disinfected the accessories, shake them vigorously and place them
on a paper towel. Alternatively, dry them with a jet of hot air (for example, from a
hair dryer).
At the end of each use store the device complete with accessories in a dry place
away from dust.
AIR FILTERING
The unit is equipped with an air lter (A3) which should be
replaced when dirty or when its colour changes. Do not wash
or re-use the used lter. The lter must be regularly replaced to
help ensure ecient compressor performance. The lter should
be regularly checked. For spare lters contact your dealer or an
authorised service centre. To replace the lter:
Pull out the dirty lter with common tweezers and push the
new one all the way in its seat. Do not replace the lter during use. Only use original
accessories and spare parts by Flaem, we disclaim any liability in the event of
using non original spare parts or accessories.
6
7