Flama 1327FL - Page 30

28 www.ama.pt
MODE buon
Press the MODE buon once to alternate
between automac mode and clothes
drying mode; the corresponding indicator
will light up.
Automac mode
When the ambient humidity ≥ + 3% of the
dened humidity, the fan will start and
the compressor will start aer 3 seconds.
When the ambient humidity is ≤ -3% of the
dened humidity, the compressor will stop
working and the fan will stop working aer
a delay of 30 seconds.
The fan speed and humidity sengs can be
adjusted in automac mode.
Clothes drying mode
In this mode, the dehumidier will opmize
the fan speed and dehumidifying capacity
to accelerate clothes drying. The standard
humidity seng is 20% and the fan speed
and humidity sengs cannot be adjusted.
TIMER buon
Press this buon to dene the mer funcon
from 0-24 hours. The increments are of
1 hour. Each me the buon is pressed,
the me will increase by 1 hour and the
corresponding me will be displayed on the
screen. The default value of “00” cancels
the mer funcon. The indicator will turn
o.
Aer the mer is dened and concluded,
the mer LED will stay lit during that period
of me. Aer the me is up, the mer LED
will turn o automacally.
While operang, set the me for the
dehumidier to turn o.
In rest mode, set the me for the humidier
to turn on.
Humidity and mer control buons
Press these buons to adjust (increase or
decrease) the humidity and me.
To adjust the humidity, press once to
increase or decrease by 5%.
To adjust the me, press once to increase or
decrease by 1 hour.
LOCK buon
Press the buon for 3 seconds to acvate
the child lock funcon. The child lock
indicator light will turn on. All buons will
be locked and non-operaonal.
Press the buon again and the indicator
light will turn o and the buon will be
deacvated.
Turning o the dehumidier will
automacally cancel the child lock funcon.
Filter REST/RESET buon
Press the rest mode buon and the indicator
will light up and acvate rest mode. Press
the buon again to turn o the funcon.
In rest mode, the fan speed will
automacally change to low and, if no
operaon occurs within 10 seconds, except
for the rest mode indicator light turning on,
all the lights will turn o.
When the room humidity is ≤ 57%, the
compressor will stop working and the fan
will stop working 30 seconds later. When
the ambient humidity is ≥ 63%, the fan
will start and the compressor will start 3
seconds later. In this mode, the fan speed
and humidity adjustment funcons cannot
be set.
In rest mode, the alarm will not sound
when the water tank is full, but the full
tank indicator light will turn on (red) as a