Flama 1327FL - Continuous Drainage

29
English
reminder that the water tank is full and
needs to be emped.
Restarng the air lter
Press and hold the rest buon for 3
seconds to restart the air lter. Once the
dehumidier has been in operaon for 600
hours, the air lter indicator light will turn
on as a reminder to clean the air lter and
the dehumidier will not work.
Proceed to clean the lter.
Press and hold the buon for some me to
restart the air lter.
Fan control buon
The fan speed can only be adjusted in
automac mode.
Press this buon to alternate between high
and low fan speed. The corresponding fan
speed indicator will turn on.
EMPTYING THE WATER TANK
When the water tank is full, the dehumidier
will emit an alert sound and the “full tank”
light will turn on.
Press the STANDBY buon to turn o the
dehumidier.
Pull on the water tank and simply slide it
out of the body of the humidier.
Empty the water down a drain or outside.
Clean the interior and exterior of the water
tank.
Return the empty water tank to
dehumidier.
Press the POWER buon to resume
operaon.
If the “full tank” buon does not turn o,
make sure that the water tank and oat are
correctly posioned.
Noce
Do not discard the water tank magnets and
plasc rivets. Otherwise, the dehumidier
will not automacally stop working when
the water tank is full, and the condensed
water will overow and damage the oor
of the room it is in.
Make sure to clean the condensed water in
the water tank before restarng operaon
of the dehumidier.
If the water tank is dirty, rinse it with clean
water. Avoid using detergents, chemical
dust removers, diesel oil, benzene, thinners
or other solvents. These will damage the
water tank and cause leaks.
Return the empty water tank to dehumidier.
Otherwise, the full tank indicator will
remain red and the dehumidier cannot
restart.
CONTINUOUS DRAINAGE
For connuous operaon or automac
dehumidicaon, connect the drain hose
to the dehumidier. The condensed water
can automacally ow to a bucket or drain
by gravity.
Straighten the drainage tube.
Insert one end of the hose into the cistern
orice and connect the other end to the
bathtub, outdoors, a bucket-like recipient,
or to a designated drainage area.
How to correctly place the drainage hose
In connuous drainage mode, the hose
should be placed below the drainage
orice. Avoid uneven surfaces and do not
bend the hose.