We reserve the right to change designs and technical specifications of our products.
Manual ENA 7-30
54
ENG
1. General
1.1. About this manual
This manual includes technical specifications, instructions and explanations that helps to use this
automat safely. Read and understand all the instructions before you transport, install, commission,
restart, operate or maintain the automat.
1.2. Other supplied documentation
General information of additional components, such as the pump and the sensors, is included in this
manual. If additional documentation is supplied, also follow the instructions in those.
1.3. Use of Flamco products
According to order or execution complementary documentations can be added. Follow the positions
performed in the dispatch papers.
1.4. Further help and information
Contact your local supplier for additional services as:
• Training.
• Maintenance agreements
• Service contracts.
• Repairs and improvements.
2. Safety
2.1. Intended use
The automat is designed for deaerating and feeding make-up water in closed heating and in cooling
water systems.
The automat is not designed for the initial filling or re-filling of systems.
2.2. Important information
The automat has safety devices intended to prevent injury and damage. Use the automat in the
following way:
Have the installation be carried out by qualified personnel.
• Comply with local legislation and guidelines.
• Do not make modifications to the automat without prior written permission of Flamco.
• Make sure that all automat covers and doors are closed when operating the automat.
• Do not touch live voltage. The sensor units and the capacity pressure sensors operate with extra
low safety voltage.
Flamco shall not be liable for any losses arising from the non-observance of safety conditions or as a
consequence of the disregard of standard precautionary measures when performing such services as
transport, installation, commissioning, re-starting, operation, maintenance, testing and repair, even in the
event that these are not expressly described in these instructions.
2.3. Signs in this manual
Identifies a hazard that could
lead to personal injury including
death/damage to the automat,
damage to other equipment and/or
environmental pollution.
Identifies an electric hazard that
could lead to personal injury
including death/ damage to
the automat, damage to other
equipment and/or environmental
pollution.
Earthing Important information
2.4. Specifications
The construction of the automat is designed in accordance with the norms DIN EN 12828.
2.5. Safety devices
The automat does not contain any safety components that prevent that the operation pressure
and the operation temperature range are exceeded or go below a limit. Install components for the
limitation of pressure and temperature in the system.
To Next Page
Loading...
