What to do if pump is air-locked and P1 and/or P2 FLOOD LIMIT is displayed on Flamco Portable Generator?
If the relevant pump on your Flamco Portable Generator is air-locked and not pumping water, and P1 and/or P2 FLOOD LIMIT is displayed, try bleeding the pump.
How to increase system pressure on flamco Midi 125D?
If the system pressure of your Flamco Portable Generator has fallen, increase the system pressure using a filling loop, or enable the SYSTEM FILL option.
What to do if PUMP TYPE option is set incorrectly on flamco Midi 125D Portable Generator?
If the PUMP TYPE option is set incorrectly on your Flamco Portable Generator, review the PUMP TYPE setting.
What to do if P2 FAIL is displayed on single pump model of Flamco Portable Generator?
If P2 FAIL is displayed on your Flamco Portable Generator, but it's a single pump model, the PUMPS NUMBER option is likely incorrectly set to 2. Set PUMPS NUMBER to 1.
What to do if pump has failed on Flamco Portable Generator?
If the relevant pump has failed on your Flamco Portable Generator, replace it.
What to do if LOW PRESSURE fault is displayed and pumps do not run on flamco Midi 125D Portable Generator?
If the LOW PRESSURE fault is displayed and the pumps do not run on your Flamco Portable Generator, and the SPC CONTROLLER option is enabled, disable the SPC CONTROLLER option. Also, review the system specifications if the LOW PRESSURE set point is too high.
Details the requirements and best practices for making pipe connections.
Lists critical conditions that must be met before starting the commissioning process.
Instructions for setting the break tank float valve to its lowest position.
Procedure for bleeding air from the pumps on Flexfiller and Midi units.
Lists and explains all fault codes that may appear on the digital controller.
Describes the checks to perform during a visual inspection for potential faults.
Troubleshooting low pressure fault and pump inactivity.
Troubleshooting high pressure fault.
Resolving pump failures, incorrect type settings, and isolation issues.
General| Voltage | 230 V |
|---|---|
| Frequency | 50 Hz |
| Fuel | Petrol |
| Rated Power | 1000 W |
| Maximum Power | 1200 W |
| Engine Type | 4-stroke |
| Phase | Single Phase |
| Starting System | Recoil |
To Next Page
