flamco Mini 130D - Bleeding Pumps Details & Warnings

www.flamcogroup.com
© 2014 Flamco group. All rights reserved.
We reserve the right to change designs and technical specifications of our products.
Rev 8.1 Aug-15 Page 21 / 44
Attach a length of hose to the hose tail on the drain valve and put the other end to drain. Then, using the cap off
the isolation valve, open the drain valve:
Locate the bleed screw on the pump. The following diagrams show examples of typical bleed screw locations for
most pumps:
Do not use excessive force when tightening the bleed screw as this may damage the pump casing.