4
How to install.
Push the drip tray in until a click
is heard.
How to insert the mesh filter.
Push onto the pipe at the bottom
of the tank until a click is heard.
Swish the active carbon filter
in water.
Insert the active carbon filter into the
separator.
How to insert the active carbon filter.
To remove the filter, press the spring clip in and remove
from the separator.
Insert the separator inside the tank.
How to insert the separator into the tank.
To remove the separator, turn it to the left and
remove in the reverse order.
Fill the tank with water up to the maximum
water level mark.
• As water enters the separator, you will here
the sound of air escaping.
Plug in the appliance, switch the
power switch to the ON position
and heat water.
Light comes on
when water has
heated.
Switch off the appliance and leave to cool.
Remove the lid and drip tray.
How to remove
the lid.
To replace, push
diagonally in.
When closing, push
into position until
you hear a click.
How to remove
the drip tray.
Dispose of any remaining
hot water through the drain.
Before using
Using the appliance for the first time or after a long time
■ Please clean the tank and water contact parts.
? Push the
spring clip of
the active
carbon filter
into the hole
in the centre
of the
separator.
spring clip
? Clip the active carbon
filter into the separator
by securing the left and
right clips with the left
and right holders.
Holder
Clip
Tank lip
Marker
? When inserting the separator
inside the tank avoid touching
the lip.
? Once past the lip, bring the
separator into a horizontal
position.
? Align the separator indent below
the marker inside the tank.
Mark inside
tank
Indent
? Turn the separator to the right
until you hear the catch click.
Then fix the
marker into
the indent
on the
other side.
Hold firmly and
pull out
• Do not use the appliance near a
source of fire (this may result in
deformation of the casing).
• Make sure that the separator is
properly inserted in the tank.
(When not properly inserted, the
separator may fall out when
disposing of unused water. Also,
heated water may become
tepid).
• Do not fill with water directly
from the tap. (Water may
overflow coming in contact with
internal electrical parts, which
may result in malfunction).
• Do not leave unused heated
water in the appliance. (Doing so
may result in corrosion to the
tank and in an unpleasant
odour).
• Do not dispose of unused water
on the side of the control panel.
Always use the drain. (Not doing
so can result in malfunction).
• Empty drip tray reqularly. Use
caution when emptying, possible
hot contents.
Notice
? Pull diagonally
away by
pressing the
‘pips’ in the
lid handle.
Lid
handle
? Hold down the
securing catch.
Remove the lid
by pulling by the
lid handle.
Securing catch
• Make sure to remove the drip tray before disposing of
unused hot water.
(Water contained in the drip tray can come into contact
with internal electric parts resulting in malfunction).
Notice
Tank
Maximum water
level
4
1
2
1
2
3
4
1
2
To Next Page
Loading...