6
1 Check that there is no filterpack left in the filterpack holder
2 Switch the power switch off and pull the plug out of the socket
3 Detach the drip tray and remove any water contained in it
4
Remove the lid and dispose of unused heated water (for the correct way to dispose of unused water please see page 4)
How to use
(continued)
Maintenance
Dispensing hot water
Storage: When you are not using the appliance for a period of time
? Hot water will not dispense in the following situations:
• While the water is being heated............................................. Please wait until the tank is in the keep warm mode.
(
Light off)
• When a used filterpack is left in the filterpack holder Remove the used filterpack
(
Light off), close the filterpack
holder and lower the start button into the original position.
* Even when the filterpack is removed from the filterpack holder, hot water will not dispense if the filterpack holder is open
or the start button is raised.
Place a cup on the cup stand.
Release Light on
the lock
To dispense hot water
• To dispense hot water, hold down . The maximum volume dispensed will be approximately 8 oz.
(Hot water will stop running as soon as the touch key is released).
• You can hold down the while releasing the lock button.
• After you have dispensed hot water, the lock will be automatically reset and the light will be cancelled.
(Even if you haven’t dispensed any water, the lock will be reset automatically after 10 seconds).
If you want to lock the hot water immediately after dispensing hot water ? press and the light will go out.
Weekly maintenance
Wipe the dust off the casing and
the lid with a well-wrung wet cloth.
• Do not wash with water.
(Water may get into the internal
electrical parts resulting in
malfunction).
• Do not use cleaning agents.
(They may leave traces).
• Do not apply any products containing
benzene to the appliance.
(This may damage the surface of the
appliance).
Wipe the walls of the tank with a wet
cloth.
• Do not clean with brushes or scouring
agents. (This may damage the
surfaces).
Filterpack holder, drip tray and cup
stand should be washed with a wet cloth.
Bi-monthly maintenance
With use, scale deposits will form on the internal
surfaces. These need to be removed once in
every two months.
How to remove
? Remove the drip tray. ? Open the
filterpack holder and push down firmly until
fully open. ? Push down again and pull out
directly downwards.
How to replace
? Insert the bottom end of the filterpack
holder by pushing diagonally upwards until
secured with the left and right pins on the
body.
? Close the filterpack holder.
* When the filterpack holder is put into
position you will hear a loud click.
Pins
Mesh filter and separator should be
cleaned by dipping in water and
agitating.
• Do not use washing up liquid or bleach.
(If this does not prove effective please
use a suitable brush).
If you observe change of color due to scale or a
floating layer in the tank.
Minerals contained in the water may form deposits
on the surfaces with which water comes in contact.
This is not corrosion of the tank itself, nor is the
change in color a change on the tank itself. The
deposits are not harmful. This may take the form of:
• Do not put in a dishwasher or dryer of any kind.
(This may result in the casing becoming deformed).
• When storing:
- Dry well.
- Protect from any objects getting into the appliance by
wrapping in plastic.
• Change of color to milky white, brown or dark grey.
• Rough surfaces or spots of rust.
• White or shiny layer due to mineral crystallisation.
Notice
Lock
Hot water button
Light on
Sanitising
• After cleaning sanitise exterior surfaces with a non-chlorine based anti-bacterial wipe or solution. Avoid scented products as this will affect the drink taste .
1
2
3
1
2
6
To Next Page
Loading...