Place a cup in the cup stand.
• Recommended cup size to be used with the appliance
is 80mm in diameter and 96mm in height.
Towards Towards Select the setting
depending on the
beverage you want.
The setting will automatically
return to after 30 seconds.
? Make your selection
again.
• Never use any other setting
but the with instant
beverage filterpacks.
On the and settings
,
an instant beverage filterpack may burst.
Press the start button.
holder.
Place the filterpack in the
filterpack holder.
Approximately 15 seconds after
closing the filterpack holder, the
‘Remove-
filterpack’ light will come on.
?
Press the
start button to
Start
operation
How to use
Water supply light.
• Water level in the tank is low.
* Please add water.
Beverage settings lights.
• How to choose between the settings:
Espresso type
For a stronger flavor and for ice drinks
• Volume of water extracted: approx. 3oz
Regular coffee/Standard leaf tea
• Volume of water extracted: approx. 7oz
Instant drink
• Volume of water extracted: approx. 6oz
Note: The volume of water extracted is pre-set.
The volume will vary depending on the type of
beverage and filterpack.
Remove filterpack
light
• This light will come
on when a used
filterpack is left in
the appliance after
making a beverage.
* Please remove the
filterpack.
1
Fill the tank with water.
2
Plug in the appliance and
turn the power switch on.
Water
heated
in the
separator.
*Approx.
3 minutes
Water
heater
*Approx.
25
minutes
Red light
Green light Green light
Green light
Comes on automatically
when water heater starts
operation.
Time required to make the
first beverage is
approximately 3 minutes.
Another cup can be made
as soon as the green light
comes on.
If a beverage is made
immediately after adding
water to the tank, the
water may not be
sufficiently hot.
Keep warm mode
* At a room temperature of 20°C and a full tank.
Smaller cups and those with a rounded bottom can cause
splashing when a beverage is dispensed.
• Only use cups suitable for hot drinks.
• Do not use plastic vending cups.
How to make a beverage
Completing your beverage
Light on
Light on
When the Remove-filterpack light comes on
Remove cup
Caution
Do not press the start button during brewing.
• For instant beverage, please stir to fully
dissolve before drinking.
Light on
After the beverage is dispensed,
open the filterpack holder and
remove the used filterpack.
• The filterpack will be hot. Take care when
removing it.
• After the beverage is dispensed, the used filterpack
must be removed. (If the filterpack is not removed,
the beverage making function and hot water
dispensing
function will not operate).
When the filterpack is removed -> Close the filterpack
holder and lower the start button into its original position.
Water heating light
• Water is heating.
* Please wait.
The light under the
selected setting will
come on.
How to heat water
Open the filterpack holder.
* Press the start button to open the
filterpack holder, re-select your
preferred beverage setting and close
the filterpack holder.
5
To Next Page
Loading...