© 1999-2007 QualityWaterForLess.com - 12 - info@qualitywaterforless.com
FIGURE 30 FIGURE 31
FIGURE 32 FIGURE 33
• To enter master programming mode, press the “UP” and “DOWN” buttons
TOGETHER and HOLD for 5 seconds, and then release the buttons, as shown in
figure 34 below.
• The display should now show “DF / GAL” as shown in figure 35 below. (This
indicates U.S. Operation Mode - Gallons) Do not change this value, and press
the “Extra Cycle Button” once to continue.
FIGURE 34 FIGURE 35
• The display should now show “VT / St1b”as shown in figure 36 on the following
page. (This indicates Valve Type 9100 Mode) Do not change this value, and
press the “Extra Cycle Button” once to continue.
To Next Page
Loading...
