Need help?Do you have a question about the Fleck 5600 SXT and is the answer not in the manual?
General| Brand | Fleck |
|---|---|
| Model | 5600 SXT |
| Category | Water Dispenser |
| Language | English |
Overview of the valve's ports and their importance for proper installation.
Details on standard programming settings for the softener, including default values.
Step-by-step guide to enter and navigate the master programming menu.
Explanation of the Flow Meter Type setting and its available options.
Important introductory information, recommendations for professional installation, and disclaimers.
How to test water hardness and convert measurements to Grains per Gallon (gpg).
Method to calculate compensated hardness, incorporating iron levels for accurate programming.
Determining optimal Unit Capacity and Brine Fill settings based on tank size and hardness.
Essential conditions and checks for system placement, power, and water access.
Instructions for selecting the final location, positioning the tank, and filling it with water.
Steps for attaching the control valve to the softener tank, including lubrication.
Connecting and securing the plumbing adapters to the control valve.
Guidance on identifying inlet/outlet ports and connecting water lines.
Locating shut-off valves, draining home water, and preparing the plumbing.
Plumbing the system using correct materials, codes, and setting up the bypass.
Steps for connecting the brine tubing to the valve and brine well.
Instructions for installing the drain port fitting and connecting the drain line.
Powering on the unit and setting the initial time to 12:01 PM.
Steps to access the advanced programming menu by holding specific buttons.
Confirming Display Format, Valve Type, and Control Type settings.
Configuring the Number of Tanks (NT) and Unit Capacity (C) values.
Inputting water hardness (H) and adjusting the Safety Factor (SF).
Setting regeneration time, backwash, brine draw, rinse, brine fill, and flow meter type.
Steps for slowly opening bypass, filling the tank, and checking for leaks.
Performing a short regeneration cycle to test all connections and functions.
Instructions for adding salt and a message confirming successful installation.
To Next Page
