19
CSM 57 18-EC
Contents
Symbols used in this manual .............19
Symbols on the product .................19
Important safety information .............19
Noise and vibration .....................21
Technical data ..........................21
Overview ..............................22
Operating instructions ..................22
Transport ..............................26
Maintenance and care ...................26
Disposal information ....................26
CE Declaration of conformity .............27
Declaration of conformity .............27
Exemption from liability .................27
Symbols used in this manual
WARNING!
Denotes impending danger. Non-observance
of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
NOTE
Denotes application tips and important
information.
Symbols on the product
To reduce the risk of injury, read
the operating instructions!
Wear eye protection!
Disposal information for the old
machine (see page 26)
CE marking
UKCA marking
Important safety information
WARNING!
Before using the power tool, please read the
following and act accordingly:
these operating instructions,
the “General safety instructions” on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
pose a danger to life and limb of the user or a
third party, or the power tool or other property
may be damaged.
The power tool may be operated only
for its intended use
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
The metal circular saw is designed
–
for commercial use in industry and trade,
–
for making cuts on metal materials.
–
Not designed for use with wood or stone
cut-off wheels.
Safety instructions for all saws
Cutting procedures
a)
DANGER: Keep hands away from
cutting area and the blade. Keep your
second hand on auxiliary handle, or
motor housing. If both hands are holding
the saw, they cannot be cut by the blade.
b) Do not reach underneath the workpiece.
The guard cannot protect you from the
blade below the workpiece.
c) Adjust the cutting depth to the thickness
of the workpiece. Less than a full tooth
of the blade teeth should be visible below
the workpiece.
d) Never hold the workpiece in your hands
or across your leg while cutting. Secure
the workpiece to a stable platform. It is
important to support the work properly to
minimise body exposure, blade binding, or
loss of control.
To Next Page
Loading...
