In Step 3 you will Install PowerSDR
A: Run the PowerSDR Installation
Wizard
Insert the CD-ROM that came with your
FLEX-5000A. The PowerSDR set-up.exe file
can be found in the PowerSDR folder.
Alternatively, PowerSDR can be downloaded
from the home page of the FlexRadio
website:
http://www.flex-radio.com/
Double click the setup.exe file to run the
PowerSDR set-up wizard. You will see the
PowerSDR Welcome screen.
If instead you see the following screen:
you will first need to install .Net 1.1 on your computer.
Information can on how to do this can be found on our
website at:
http://kc.flex-radio.com/KnowledgebaseArticle50072.aspx
You will also need the .Net 1.1 Service Pack 1. See:
http://kc.flex-radio.com/KnowledgebaseArticle50073.aspx
Click Next on this and subsequent screens,
accepting the License Agreement and all
defaults. PowerSDR will be installed on your
computer, after which an Installation
Complete screen will appear. Click Close to
complete the installation.
Step 3: Install PowerSDR
B: Run the PowerSDR Setup Wizard
Make sure your FLEX-5000A is powered up
and run PowerSDR, either by double-
clicking on the desktop icon you created
during installation, or clicking on Start,
then All Programs, PowerSDR and select
the PowerSDR version you just installed
(if this is not the first time you have
installed PowerSDR, you may have multiple
versions on your computer).
The first time PowerSDR starts up it will
first run an optimization routine. Click OK
and let the routine run.
Next the PowerSDR Setup Wizard will start
and a Welcome screen will open. Click
Next.
You will be asked to select your Radio
Model. Select FLEX-5000 and click Next.
You will then be informed that the Wizard is
finished. Click Finish to complete the
wizard.
PowerSDR next transfers your FLEX-5000A's
calibration data to the computer. This only
happens once, the first time you run a new
release of PowerSDR.
Click OK to start the transfer process.
If you have the second receiver (RX2) installed, this
transfer of data will be followed by a second transfer.
When the transfer process is complete,
PowerSDR will finish starting up and display
its front console.
Do not click the Start button just yet.
Proceed to Step 4: Configure the FLEX-5000
Device Driver on the next page.
To Next Page
Loading...
