In Step 4 you will configure the Device Driver's Sampling Rate, Buffer Size
and Operation Mode to work correctly with your FLEX-5000A.
Set the Sampling Rate and Buffer Size
Locate the Device Driver icon on your desktop and double-click on it to open
the Control Panel.
If you did not elect to create a desktop icon during installation, click on Start, then All Programs,
select the FlexRadio FLEX-5000 folder and double-click on the FlexRadio FLEX-5000
application.
In the top section, make sure the Bus tab on the left is selected. Set the
Sampling Rate to 96kHz and the Buffer Size to 1024. Remember these
settings as you will need them in Step 5-A.
Set the Operation Mode
Now select the Advanced tab on the right. Set the Operation Mode to Safe
Mode Level 1.
Proceed to Step 5: Configure PowerSDR on the next page.
Step 4: Configure the FLEX-5000 Device Driver
To Next Page
Loading...
