FLIR A50 Series User Manual

RTSP Streams
9
It is possible to establish streaming sessions with the Smart Sensor, the Advanced Smart
Sensor, and the Advanced Image Streaming cameras of the FLIR A50/A70 series.
The following URLs can be used:
• rtsp://<IP>/avc/
• rtsp://<IP>/mpeg4/
• rtsp://<IP>/mjpg/
• rtsp://<IP>/avc/ch1
• rtsp://<IP>/mpeg4/ch1
• rtsp://<IP>/mjpg/ch1
The section after IP address refers to the encoding:
• /avc = H264 encoding
• /mpeg4 = MPEG4 encoding
• /mjpg = Motion JPEG encoding
The section after the encoding refers to the source, which can be either / or /ch1:
• / will start a streaming session giving you the identical video as seen in the web inter-
face. This can be IR, visual, MSX, or FSX, and the feed is 640 x 480 pixels.
Add the &overlay=off argument in the URL to receive a feed without overlay.
• /ch1 will start a streaming session giving you the uncropped visual image at 1280 x
960 pixels.
A radiometric 16-bit stream is also available for software supporting it.
#T810579; r. AB/78918/78918; en-US
15

FLIR A50 Series Specifications

General

Product Type	Thermal Imaging Camera
Thermal Sensitivity	< 30 mK
Frame Rate	30 Hz
Infrared Resolution	464 x 348 pixels
Temperature Range	-20 °C to 150 °C (-4 °F to 302 °F)
Accuracy	±2°C or ±2% of reading
Video Output	GigE Vision
Power Requirements	Power over Ethernet (PoE) Class 0
Storage Temperature	-40 °C to 70 °C (-40 °F to 158 °F)
Humidity	IEC 60068-2-30 (95% non-condensing)
Operating Temperature	-15°C to +50°C