FLIR Ariel Gen III CB-3304 - User Manual

Quick Install Guide
Ariel Gen III
CB-3304/CB-3308
4MP/8MP Bullet IP Camera
A. Use this QR Code
to access the FLIR Website
What's in the Box
Item
CB-3304
CB-3308
CB-330x Camera
1pc
1pc
Tapping Screw s (TP4
31mm)
3pcs
3pcs
Plastic anchors
3pcs
3pcs
T6 Torx w rench
1pc
1pcs
Drill template
1pc
1pcs
Quick Installation Guide
1pc
1pcs
Water proof cap
1pc
1pcs
Example - CB-3308-11
B. Download Camera Documentation
and Utility Software from the Web
C. Install the SD Card if required
Only required if Storage on the Edge is going to be used. (see User Guide)
A microSDXC card (not supplied) must be inserted in the card drive on the connector panel in order to locally store a snapshots or recordings triggered by events.
Insert a microSDXC card (Min 4GB, up to 128GB, Class 10) in the card drive.
After the camera is connected to the VMS:
1. Use the camera web page to verify that the card status is displayed as mounted in the System > Events Handler > SD Card screen.
2. Format the card. Card must be formatted as a single partition.
3. Configure the camera to store snapshots and recordings from the System > Events Source screens.

Summary

Download Camera Software & Docs

Download User Guide & DNA Software

Download user guides and the DNA utility software from the FLIR website.

Mount and Connect Camera

Connect Network and PoE

Connect the camera to the network switch via RJ-45 and PoE.

Discover Camera on Network

Discover Camera IP & Set Config

Use DNA utility to find the camera IP and configure its network settings.

Attach Camera to VMS

Add Camera to VMS

Use VMS discovery to add the camera to your Video Management System.

FLIR Ariel Gen III CB-3304 Specifications