FLIR LOREX LW2770HAC1 - User Manual

LW2770HAC1_QSG_R1 Page 1
ADD-ON CAMERA
LW2770HAC1
QUICK START GUIDE
x1 x3 x1
Loosen the thumbscrews (1, 2) and the adjustment
2 ring (3) by turning them counter clockwise.
2
1
Use the included mounting screws to attach the
camera(s) to the mounting surface:
a. Mark the positions of the screw holes on the mounting surface.
b. Drill holes and insert the drywall anchors (included) as needed.
c. Firmly attach camera(s) to the surface using the included screws.
Adjust the angle
of the camera(s) as
needed, then tighten
the thumbscrews and
the adjustment ring.
Camera Setup
Before installing camera(s), carefully plan where and
how it will be positioned, and where you will route the
cable that connects the camera to the power adapter.
3
Connect one end of the camera’s power adapter to
the camera and the other end to an electrical outlet.
Make sure the power connector is fully inserted
to avoid water getting in the plug.
4
Remove the protective film from the front of the
camera(s). If the film is not removed, it will block
the microphone and will affect picture quality.
• Cameras are rated for indoor/outdoor installation, but are not
intended for direct exposure to rain or snow. For outdoor applications,
install under shelter protected from the elements.
• Wireless cameras require a power source to operate.
• Ensure power outlets are sheltered from the elements.
Installation Tips
NOTE: If you run the power cable through the mounting surface,
connect power before attaching the camera to the wall.
Tap , then go to General Settings > Camera Setup >
Pairing.
2
1
Connect the new camera to a power outlet. Place the camera
within 1ft of the wireless receiver.
Pairing the Camera with the Receiver
3
Select the channel you wish to pair
the camera to.
4
What’s Included
NOTE: If you pair a new camera to a channel that is already being
used by an existing camera, the new camera will be connected to
that channel. The old camera will automatically be disconnected.
Following the on-screen prompt,
you have 30 seconds to press
the Pair button on the camera.
NOTE: If you do not press the Pair button on the camera during
the 30 second pairing window, repeat steps 2~4 to try the pairing
process again.
NOTE: If the speaker begins squealing, move the camera and
receiver away from each other.
1ft
Once paired, the camera will be immediately displayed on-screen.
2
1
3
1
2
3
4
For software and instructional manual:
Visit www.lorextechnology.com
Search your product’s model number
Select your product from the search results
Click the Downloads tab

Summary

Pairing the Camera with the Receiver

Pairing Process Steps

Connect camera, navigate receiver settings, select channel, and press camera pair button within 30 seconds.

Camera Setup and Installation

Mounting the Camera

Use included screws to attach camera to mounting surface, marking and drilling as needed.

Adjusting Camera Angle

Loosen thumbscrews and adjustment ring to angle camera, then tighten them securely.

Power Connection and Protection

Connect camera power adapter to outlet and remove front protective film for clear audio.

Installation Tips

General Installation Guidelines

Plan positioning, ensure outdoor shelter, and secure power outlets from elements.

FLIR LOREX LW2770HAC1 Specifications

General

Brand	FLIR LOREX
Model	LW2770HAC1
Category	Security Camera
Camera Type	Bullet
Field of View	90°
Weather Resistance	Yes
Power Supply	12V DC
Night Vision	Yes, up to 130 feet
Weatherproof	Yes
Features	Motion detection
Operating Temperature	-40°F to 140°F (-40°C to 60°C)