To Next PageTo Next Page
Need help?Do you have a question about the FLIR SR-100 and is the answer not in the manual?
General| Frame Rate | 30 Hz |
|---|---|
| Spectral Range | 7.5 - 13.5 µm |
| Focus | Manual |
| Sensor Type | Uncooled Microbolometer |
| Field of View | 24° x 18° |
| Video Output | NTSC or PAL composite video |
| Power Requirements | 12VDC |
| Operating Temperature | -15°C to +50°C |
| Storage Temperature | -40°C to +70°C |
Explains the use of the term "Caution!" to denote potentially hazardous situations.
Advises on proper installation, ESD protocol, and handling of the precision optical instrument.
Explains proper grounding for surge protection, CE/FCC compliance, and protection against electrical events.
Specifies operating voltage requirements (24VDC/24VAC) and fuse protection for SR-Series cameras.
Outlines RS-232/RS-422 communication options using PC software or protocol converters.
Details the connection terminal for power, serial, and video inputs on the SR-100.
Lists pin definitions, directions, and comments for the SR-100 camera's screw terminals.
Lists pin assignments for video, power, and serial signals on the SR-100P mating connector.
Explains configuring serial protocol (RS-232/RS-422) using DIP switches on applicable models.
Guides on connecting power, video, and communication leads to the camera's interface board.
Discusses serial interface settings, focus control, and software for camera setup.
Offers solutions for common issues like no video, noisy images, focus, and performance variations.
Lists keyboard commands and their corresponding camera functions for control.
Describes the video control section of the TVIS-7 interface, including FFC, EZoom, and ROI settings.
