FLIR Ariel Mini-Dome CM-3202-11-I - Attach Camera Cover; Attach the Camera to a VMS; Camera Dimensions; Register the Product

CM-3202-11-I QIG Rev 100
June 2020
This document does not contain any export-controlled information.
4.4 Attach Camera Cover
a. Carefully place the top cover onto the
camera body (1).
b. Fasten the three Torx screws
clockwise to complete the mounting
(2).
4.5 Attach the Camera to a VMS
After you have mounted the camera and discovered or defined its IP address, you
can use VMS Discovery/Attach procedures to attach the camera to a VMS.
5. Camera Dimensions
The Ariel CM-3202-11-I camera’s dimensions are:
Side Dimensions
Base Dimensions
6. Register the Product
Register your Product with FLIR at https://customer.flir.com.
For warranty information, see https://www.flir.com/support-
center/warranty/security/flir-security-product-warranties/.
7. Contact Information
FLIR Systems, Inc.
6769 Hollister Avenue
Goleta, CA 93117
USA
Support: https://www.flir.com/support/
product.enterprise.support@flir.com
Corporate Headquarters
27700 SW Parkway Ave.
Wilsonville, OR 97070
USA