Operation
8
8.2 Turning on and turning off the camera
• Push the button to turn on the camera.
• Push and hold the
button for less than 5 seconds to put the camera in standby
mode. The camera then automatically turns off after 48 hours.
• Push and hold the
button for more than 10 seconds to turn off the camera.
8.3 Saving an image
8.3.1 General
You can save multiple images to the internal camera memory.
8.3.2 Image capacity
Approximately 500 images can be saved to the internal camera memory.
8.3.3 Naming convention
The naming convention for images is FLIRxxxx.jpg, where xxxx is a unique counter.
8.3.4 Procedure
Follow this procedure:
1. To save an image, pull the trigger.
8.4 Recalling an image
8.4.1 General
When you save an image, it is stored in the internal camera memory. To display the image
again, you can recall it from the internal camera memory.
8.4.2 Procedure
Follow this procedure:
1. Push the Archive button
.
2. Push the navigation pad left/right or up/down to select the image you want to view.
3. Push the center of the navigation pad. This displays the selected image.
#T559828; r. AK/40423/40448; en-US
18
To Next Page
Loading...
Need help?
General
