How to stop the FLIR M3208 DVR system from beeping during motion detection?
The system beeps during motion detection because motion detection is enabled and the alarm buzzer is activated. To disable it, go to the Main Menu, click Event>Motion>Motion Detect, uncheck Buzzer for each channel, and click Apply.
Why is there no picture on my monitor/TV after connecting it to the FLIR M3208 system?
There might be several reasons: * The monitor/TV may not be detected by the system. Try powering off both the monitor/TV and the DVR system, then power on the monitor/TV first, followed by the system. * The input channel for the system may not be selected on the monitor/TV. Ensure that you select the correct input channel on your monitor/TV to which the DVR system is connected. * The video cable might be loose or disconnected. Check the video cable connection at both the DVR system and the monitor/TV.
What to do if my FLIR DVR system is not receiving power or not powering up?
If your FLIR DVR system isn't powering up, here's what to check: * Ensure the cable from the power adapter is securely connected to the back of the unit and to the power outlet. * Verify that the power switch is in the ON (I) position. * Confirm the system is powered on by checking for LED indicators on the front. * If connected to a power bar or surge protector, try connecting directly to the wall outlet. * Test the outlet with another device or try a different outlet.
Why is my hard drive full on my FLIR DVR (0%) and the unit is no longer recording?
The hard drive might be full because the overwrite function is not enabled. To resolve this, go to the Main Menu, then navigate to Setting>General>General. Under HDD Full, select Overwrite and click OK.
What to do if the mouse is not detected by my FLIR M3208 DVR system?
If your mouse isn't being detected by the FLIR DVR system: * Make sure the mouse cable is firmly connected to one of the USB ports. * If that doesn't work, power off the system (disconnect the power cable), firmly connect the USB mouse to a USB port, and then reconnect the power cable.
General| Power Supply | 12 VDC |
|---|---|
| Video Output | HDMI, VGA |
| Compression | H.264 |
| Network Interface | 1x RJ45 |
| Operating Temperature | -10°C to 55°C |
To Next Page
