Floe VSD 6000 - Page 15

15
STEP 6 (VSD 5000 AND VSD 6000-10000)
-ALIGN CANOPY
ALIGN RAILS (SHOWN ASSEMBLED WITH HOOPS) ON LIFT TO DESIRED OVERHANG.
ARRANGEMENT WILL DEPEND ON POSITION OF BOAT ON LIFT (FIG.1).
IMPORTANT:
IMPORTANT: IMPORTANT:
IMPORTANT: WHEN
WHENWHEN
WHEN ASSEMBL
ASSEMBLASSEMBL
ASSEMBLING
ING ING
ING CANOPY, PLACE END HOOPS WITH RIVET NUTS
CANOPY, PLACE END HOOPS WITH RIVET NUTS CANOPY, PLACE END HOOPS WITH RIVET NUTS
CANOPY, PLACE END HOOPS WITH RIVET NUTS
FACING INWARDS.
FACING INWARDS.FACING INWARDS.
FACING INWARDS. THIS IS FOR ATTACHMENT OF THE
THIS IS FOR ATTACHMENT OF THETHIS IS FOR ATTACHMENT OF THE
THIS IS FOR ATTACHMENT OF THE END HOOP SUPPORT BRACKETS
END HOOP SUPPORT BRACKETSEND HOOP SUPPORT BRACKETS
END HOOP SUPPORT BRACKETS.
. .
.
THE BRACKETS SHOWN IN
THE BRACKETS SHOWN IN THE BRACKETS SHOWN IN
THE BRACKETS SHOWN IN FI
FIFI
FIGURE 2
GURE 2GURE 2
GURE 2 ARE PLACED ON THE NON
ARE PLACED ON THE NONARE PLACED ON THE NON
ARE PLACED ON THE NON-
--
-TILTING SIDE. THE
TILTING SIDE. THE TILTING SIDE. THE
TILTING SIDE. THE
BRACKETS SHOWN IN
BRACKETS SHOWN IN BRACKETS SHOWN IN
BRACKETS SHOWN IN FIGURE 3
FIGURE 3FIGURE 3
FIGURE 3 ARE PLACED ON THE TILTING SIDE.
ARE PLACED ON THE TILTING SIDE.ARE PLACED ON THE TILTING SIDE.
ARE PLACED ON THE TILTING SIDE.
FIG. 1
OVERHANG
DEPENDANT
ON BOAT’S
POSITON.
BOAT’S
CENTER OF
GRAVITY
SHOULD BE
CENTERED
ON LIFT.
FIG. 2
FIG. 3
HOOPS & END SUPPORTS NOT INCLUDED WITH TILT KIT