Floe VSD 6000 - Page 7

7
512-65001-00
(VSD 6000-10000)
-PLACING CANOPY LEGS
INSERT A CANOPY LEG (INCLUDED IN CANOPY HOOP
(INCLUDED IN CANOPY HOOP(INCLUDED IN CANOPY HOOP
(INCLUDED IN CANOPY HOOPS
SS
S)
) )
) IN EACH OF THE CORNER
POSTS.
. .
. TILTING LEGS (002-00170-00, SHOWN BELOW) ARE PLACED IN PIVOTING SIDE
(SHORE-END) CORNER POSTS. NON-TILTING LEGS (002-00172-00) ARE PLACED IN
NON PIVOTING SIDE CORNER POSTS. ATTACH USING A ½-13 x 1 1/4” BOLT, FLAT
WASHER, AND NYLOCK NUT (INCLUDED WITH CANOPY HOOP
(INCLUDED WITH CANOPY HOOP(INCLUDED WITH CANOPY HOOP
(INCLUDED WITH CANOPY HOOPS
SS
S)
))
). (FIG. 1).
PLACE BOLT AND WASHER IN CORNER POST. (FIG. 2).
SLIDE CANOPY LEG INTO CORNER POST. BOLT AND WASHER ARE INSERTED INTO
CANOPY LEG NUT TRACK. (FIG. 3).
WHEN PLACING NON
WHEN PLACING NONWHEN PLACING NON
WHEN PLACING NON-
--
-TILTING LEG INTO CORNER POST, FACE HOLES TOWARDS
TILTING LEG INTO CORNER POST, FACE HOLES TOWARDS TILTING LEG INTO CORNER POST, FACE HOLES TOWARDS
TILTING LEG INTO CORNER POST, FACE HOLES TOWARDS
INSIDE OF LIFT
INSIDE OF LIFT INSIDE OF LIFT
INSIDE OF LIFT (FIG. 4).
PLACE ASC ONTO BOLT. (FIG. 5).
LEG MUST BE INSERTED TO HAVE 18 INCHES ABOVE CORNER POST.
LEG MUST BE INSERTED TO HAVE 18 INCHES ABOVE CORNER POST.LEG MUST BE INSERTED TO HAVE 18 INCHES ABOVE CORNER POST.
LEG MUST BE INSERTED TO HAVE 18 INCHES ABOVE CORNER POST.
PLACE NUT ON BOLT. TORQUE TO 60 FT/LBS.
TORQUE TO 60 FT/LBS.TORQUE TO 60 FT/LBS.
TORQUE TO 60 FT/LBS. (FIG. 6).
FIG. 1
FIG. 2
FASTENERS
FASTENERS FASTENERS
FASTENERS
INCLUDED
INCLUDED INCLUDED
INCLUDED
WITH HOOP
WITH HOOP WITH HOOP
WITH HOOP
HARDWARE
HARDWARE HARDWARE
HARDWARE
CARD
CARD CARD
CARD