FLORABEST 73433 - User Manual

Questions and Answers

C
Chelsea FordAug 16, 2025
Why my FLORABEST 73433 device does not start?
- B
  Brian MejiaAug 16, 2025
  If your FLORABEST Lawn and Garden Equipment device does not start, several issues could be the cause. It could be due to a defective mains voltage or an activated house protection fuse. In this case, check the plug socket, cable, line, and plug, repairing them if necessary by an electrical specialist, and inspect the house protection fuse. The problem might also stem from a defective On/Off switch, worn carbon brushes, or a defective motor, all of which require repair by customer service.
K
Kenneth MooreAug 19, 2025
What to do if chain (1) becomes hot on FLORABEST Lawn and Garden Equipment?
- K
  Kenneth HernandezAug 19, 2025
  If the saw chain (1) becomes hot, you notice smoke during sawing, or the rail becomes discolored on your FLORABEST Lawn and Garden Equipment, it's likely due to insufficient chain oil. Check the oil level and refill with chain oil if needed. Also, inspect the oil automatic system and clean the oil outlet channel (17) or have it repaired by customer service. Check the fine-tuning for the lubrication system (oil regulation button).
J
Johnny ScottAug 22, 2025
How to improve cutting performance of FLORABEST 73433?
- A
  Ashley MorenoAug 22, 2025
  If you're experiencing inferior cutting performance with your FLORABEST Lawn and Garden Equipment, it could be due to a few reasons. First, ensure the saw chain (1) is mounted correctly. If it is, the saw chain (1) might be blunt, requiring you to sharpen the cutting teeth or replace the chain. Also, check the chain tension to ensure it's sufficient.
E
Emily GarrettAug 26, 2025
Why does the chain (1) come off FLORABEST 73433 Lawn and Garden Equipment?
- W
  William ContrerasAug 26, 2025
  If your FLORABEST Lawn and Garden Equipment saw runs with difficulty and the chain (1) comes off, the chain tension is likely insufficient. Check the chain tension to resolve this issue.
J
Jay ScottAug 28, 2025
How to fix a telescopic handle that cannot be locked on FLORABEST 73433?
- W
  woodardbenjaminAug 28, 2025
  If the telescopic handle on your FLORABEST Lawn and Garden Equipment cannot be locked, it may be due to the Allen screw (15b) being loose on the quick release (15). Try tightening the Allen screw (15b) to secure the handle.
M
Mr. Mark MeyerAug 31, 2025
What to do if my FLORABEST Lawn and Garden Equipment does not start?
- M
  Mary BlakeAug 31, 2025
  If your FLORABEST Lawn and Garden Equipment device does not start, the issue could be due to several reasons. First, examine the mains voltage for any defects by checking the plug socket, cable, line, and plug, and if necessary, have an electrical specialist repair them. Also, check the house protection fuse. Alternatively, the On/Off switch may be defective, or the carbon brushes could be worn. In these cases, it is best to seek repair by customer service. A defective motor may also be the reason, which also requires repair by customer service.
S
Sarah HudsonSep 3, 2025
Why is my FLORABEST Lawn and Garden Equipment cutting performance inferior?
- J
  Jennifer GordonSep 3, 2025
  If you're experiencing inferior cutting performance with your FLORABEST Lawn and Garden Equipment, there are a few potential causes. Make sure the saw chain is mounted correctly. If the saw chain is blunt, sharpen the cutting teeth or replace it with a new chain. Also, check the chain tension to ensure it is sufficient.
M
Michael LivingstonSep 6, 2025
What to do if chain (1) becomes hot with FLORABEST 73433?
- W
  William MorrisSep 6, 2025
  If the chain is getting hot, smoke is developing during sawing, and the rail is discolored when using your FLORABEST Lawn and Garden Equipment, it's likely due to too little chain oil. Check the oil level and refill with chain oil if needed. Also, inspect the oil automatic system and clean the oil outlet channel, or have it repaired by customer service. Check fine-tuning for lubrication system (oil regulation button).
Z
Zachary RobertsSep 9, 2025
Why does my FLORABEST Lawn and Garden Equipment saw run with difficulty and the chain (1) comes off?
- Y
  youngannetteSep 9, 2025
  If your FLORABEST Lawn and Garden Equipment saw runs with difficulty and the chain comes off, the most likely cause is insufficient chain tension. You should check the chain tension.
J
Jessica SotoSep 12, 2025
How to fix FLORABEST 73433 telescopic handle that cannot be locked?
- S
  stephanie38Sep 12, 2025
  If the telescopic handle of your FLORABEST Lawn and Garden Equipment cannot be locked, the Allen screw on the quick release may be loose. Try tightening the Allen screw to resolve this issue.