To Next PageTo Next PageWhy does my FLORABEST Lawn Mower engine over-heats?
If your FLORABEST Lawn Mower engine is overheating, it might be due to a few reasons. Check if the ventilation slot is blocked and clean it if necessary. Another possible cause is using the incorrect spark plug, which would require a replacement. Also, ensure there is enough engine oil; if it's too low, fill it to the recommended level.
What to do if my FLORABEST Lawn Mower output is unsatisfactory?
If your FLORABEST Lawn Mower's output is unsatisfactory or the engine is laboring, consider these points: the grass might be too short or too long, so adjust the cutting height accordingly. Also, check if the blade is blocked with grass, the grass collection box is full, or the ejection channel is blocked; remove the grass in such cases.
Why FLORABEST Lawn Mower starts but does not run at full power?
If your FLORABEST Lawn Mower starts but doesn't run at full power, a dirty air filter could be the cause. Replace the air filter. Also, make sure the throttle is in the correct position.
What to do if FLORABEST Lawn Mower engine does not start?
If your FLORABEST Lawn Mower engine isn't starting, check if the spark plug connector is correctly attached. If not, attach it properly. Also, the spark plug might be sooted, requiring cleaning, adjustment, or replacement.
Why does my FLORABEST Lawn Mower engine splutter and stop?
If your FLORABEST Lawn Mower engine splutters and stops, it could be due to a sooted spark plug. Clean, adjust, or replace the spark plugs.
What if blade does not turn on FLORABEST Lawn Mower?
If the blade of your FLORABEST Lawn Mower does not turn, it might be blocked with grass. Remove the grass.
Why FLORABEST Lawn Mower engine does not start?
If your FLORABEST Lawn Mower engine won't start, it could be due to several reasons. First, ensure there is enough petrol in the tank; if not, fill it up. Another reason may be an incorrect starting sequence, so make sure you are following the correct procedure. Also, check the spark plug connector to ensure it's correctly attached and that the spark plug isn't sooted; clean, adjust, or replace it if necessary. Finally, the carburetor mix might be incorrectly adjusted, in which case you should have it adjusted by a specialist workshop.
What to do if FLORABEST Lawn Mower engine splutters and stops?
If your FLORABEST Lawn Mower engine sputters and stops, it could be due to an incorrectly adjusted carburetor mix, which should be adjusted by a specialist workshop. Another possible cause is a sooted spark plug, which should be cleaned, adjusted, or replaced.
What to do if FLORABEST Lawn Mower blade does not turn?
If the blade of your FLORABEST Lawn Mower does not turn, it might be blocked with grass; remove the grass. Alternatively, the blade may not be installed correctly, and you should have it installed by a specialist workshop.
How to fix abnormal noises from FLORABEST Lawn Mower?
If your FLORABEST Lawn Mower is making abnormal noises, rattling, or vibrating, the blade may not be installed correctly. Have the blade installed by a specialist workshop.
General| Power | 1900 W |
|---|---|
| Voltage | 230 V |
| Frequency | 50 Hz |
| Cutting Height Adjustment (Approx.) | 20-70 mm |
| Cutting Height Adjustment | 6-stage central |
