How to fix a Flotec FP5112 when the motor will not run?
If the motor of your Flotec Water Pump will not run, the fuse may be blown, or the circuit breaker may be tripped. Disconnect the power, then replace the fuse or reset the circuit breaker.
What to do if Flotec Water Pump does not deliver water to full capacity?
If your Flotec Water Pump isn't delivering water to its full capacity, it could be due to several factors: * The water source being lower than estimated. * A deep well jet will be needed if your well is more than 25’ (7.6M) depth to water. * Corroded pipes or hoses. Replace with plastic or new steel pipe. * Piping is too small in size. Re-pipe using pipe the same size as suction and discharge ports on pump. The inlet pipe may also be too small.
What to do if my Flotec FP5112 motor runs but no water is delivered?
If your Flotec Water Pump motor runs but no water is delivered, it could be due to several reasons: * **New Installation Issues:** Improper priming, air leaks in the suction line, a leaking foot valve, or the pipe size being too small. * **Solutions:** Re-prime the pump according to instructions. Check all connections on the suction line for air leaks using soapy water or shaving cream. Replace the foot valve if it's leaking. Re-pipe using pipe the same size as the suction and discharge ports on the pump. * **Existing Installation Issues:** Air leaks in the suction line, the water level being below the suction pipe inlet, a plugged impeller, a stuck foot valve, frozen pipes, or the foot valve/strainer being buried in sand or mud. * **Solutions:** Check all connections on t...
Provides critical safety warnings and symbols for pump operation and maintenance.
States product contains chemicals known to cause cancer or reproductive harm.
Covers risks such as explosion, fire, dry running, and property damage.
Details risks of electric shock and proper grounding and connection procedures.
Covers defects in material and workmanship for a specified period from purchase.
Outlines specific warranty periods for different product types and exclusions.
Specifies limitations, remedies, and disclaimers for warranty claims.
Instructions for pump usage, avoiding clogging, and proper pipe sealing.
Step-by-step guide to prime the pump for optimal water delivery.
Guidance for pumping from lakes, streams, and ponds, including piping.
Instructions for connecting the pump for city water boosting and lawn sprinkling.
Details on safe electrical hookup, including GFCI and extension cords.
Information on motor lubrication, pump seal, and service safety.
Details GPM and LPM at various total feet of lift for the FP5112 model.
Identifies pump symptoms, possible causes, and corrective actions.
Lists all key parts with their corresponding numbers and quantities for the FP5112 pump.
General| Horsepower | 1/2 HP |
|---|---|
| Maximum Head | 25 ft |
| Voltage | 115V |
| Pump Type | Submersible |
| Power Source | Electric |
| Construction | Thermoplastic |
| Switch Type | Vertical Float |
| Discharge Size | 1-1/2 in |
| Outlet Size | 1-1/2 in |
To Next Page
