flowair T-box - Page 60

124 125www.owair.com
Capacity setting
Capacity setting - gas detector
active operating mode active operating mode
Activate the functions of working with a gas detector -
see section „External gas detector” on page 14.
You need to dene 3 parameter values:
- normal working condition
- 1 - rst level of alarm from gas detector
- 2 - second level of alarm from gas detector
airow setting
The icon informs that the parameter has
been dened in the calendar. It is possible
to change the parameter temporarily.
The change will only be active in a given
calendar zone
Thermostatic mode - Fans turn OFF after
reaching the set temperature. The option is
not available when the device is operating
in according to the supply air temperature
sensor as a leading sensor.
The selection of the leading/master sensor
from: supply air, exhaust air and wall
temperature sensors is made during rst
startup. It is also possible to dene built in
sensor in T-box sensor he leading sensor
Therm
Cube
capacity
Cube
capacity