Fluance DB10 - FCC & IC Information

13
20. Do not attempt to clean this unit
with chemical solvents as this might
damage the finish. Use a clean
dry cloth.
21. Operate controls and switches as
described in the manual. Before
turning on the power, make certain
that power cord is properly installed.
22. When moving the apparatus, be sure
to first disconnect the power cord.
23. Use caution when wearing loose
clothing or articles near the spinning
turntable.
FCC & IC Information
Important!
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. This digital apparatus does not
exceed the Class B limits for radio noise emissions from digital apparatus as set out in
the Radio Interference Regulations of Industry Canada.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Since digital circuitry may cause interference to other radio or television tuners nearby,
switch this unit off when not in use or move it away from the affected radio/television tuner.
• Re-orient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause undesired
operation