7
Auto Setting
Phase Setting
By selecting the Auto setting, the Subwoofer will automatically turn on when it detects
a signal from the home theater receiver. The auto setting turns the Subwoofer on when
the frequency signal reaches a required voltage. A 100Hz signal requires 3mV and a
1KHz signal requires 5mV.
If your speaker system or DB10 is out of phase, it means that the driver/woofer is
moving in the opposite direction of the other drivers/woofers. This causes frequencies
to be canceled out, which can result in a poor listening experience. By adjusting the
phase setting of the DB10, you can ensure the DB10’s woofer is moving in the same
direction as your other speakers, which will result in a more pleasant listening experience.
To Next Page
Loading...
