Fluid Components Intl ST98 - Verify the Calibration Parameters; Table 5-2. Diagnostic Test Sequence on Display

FLUID COMPONENTS INTL CHAPTER 5 - TROUBLESHOOTING
Model ST98 Flow Meter 5 - 4 Doc. No. 06EN003291 Rev. A
Example: (Metric: P
S
= 1.01325 bar(a)
Q
A
= 1212.7 ACFM Q
S
= 1485 SCFM T
S
= 21.1°C (294.1K))
P
A
= 19.7 PSIA T
A
= 120°F (580°R)
P
S
= 14.7 PSIA T
S
= 70°F (530°R)
Verify the Calibration Parameters
The instrument uses a set of predetermined calibration parameters to process flow signals. Most of these
parameters should not change. A data package located at the rear of this manual contains the “ST98 Delta R Data
Sheet”. This contains the calibration ST98 parameters stored in the flow transmitter at the factory. To verify that
these parameters have not changed, complete the following:
1. Identify the appropriate Delta R Data sheets by serial number of the instrument.
2. Press [D] [ENTER] to examine each of the parameters. The [ENTER] key allows scrolling one message at a
time. Use Table 5-2 to verify parameters with the Delta R Data sheet ST98 Parameters.
Table 5-2. Diagnostic Test Sequence on Display
If parameters that have an asterisk (*) have changed, this may indicate a problem. Customer Service should be
contacted. If the parameters have not changed, continue with the next section.
.oNlaireS:ue
.oN.tsuC:tifevruc
:elacs:edomtuo
:1c*:wolfxam*
:2c*:wolfnim*
:3c*:D/AxaM*
:4c*:tot
:5c*:wolft
:6c*:D/AniM*
:7c*:ytisneD*
:8c*:rotcaF-K
:9c*:orez
01c*:rosnes*
:pmetlac*:plst*
:ecnalab*:0plsct*
:ztuo*:plsct*
:ftuo*:2plsct*
:iretaeh*0ezisenil
:ffot*:1ezisenil
:rotcaf:.S.F
( )
530° R .
14.7 PSIA
= 1485 SCFM
( )
19.7 PSIA
580° R
( )
1212.7 ACFM
1