Fluidmaster PerforMAX 400CAR3 User Manual

8 9
STEP 6: INSTALL NEW FILL VALVE
D: INSTALL LOCKNUT
Screw locknut to the right
(counterclockwise) onto fill valve shank (below tank).
*Hand-tighten only. DO NOT OVER TIGHTEN.
C: ATTACH REFILL CLIP TO OTHER END
OF REFILL TUBE
D: INSERT FILL VALVE
Position refill tube to face flush valve making sure fill
valve parts do not interfere with lever arm.
RIGHT
E: ATTACH REFILL CLIP TO OVERFLOW PIPE
Note: If refill tube is too long to fit inside tank
with lid closed, remove refill tube from fill valve
refill port, cut tube, and reattach to port.
Scissors
(Optional)
TOP
DOWN
VIEW
Refill Tube
Lever Arm
Overflow
Pipe
Fill Valve
STEP 7: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right
(counterclockwise)
*Hand-tighten only.
DO NOT OVER TIGHTEN.
RIGHT
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½ inch below top of overflow pipe to ensure a
proper flush. (Does not need to be exact.)
B:
TURN ON WATER
Check for leaks.
TURN
COUNTER-
CLOCKWISE
A: INSTALL SHANK WASHER
Pull up to top of shank.
* Place shank washer onto
threaded shank of fill valve.
WIDE SIDE UP.
B: PUSH REFILL TUBE ONTO REFILL
PORT FIRST
Squeeze tube clamp arms and move it
towards refill port.
Shank Washer
Threaded Shank
Refill Clip
Refill Tube
Clamp Arms
Refill
Port
Overtightening may damage fill valve or coupling nut, potentially causing flooding. Make sure
the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
*
1/2"
Overflow Pipe
Top of
Overflow Pipe
Water Level
**Lever Hole

Fluidmaster PerforMAX 400CAR3 Specifications

General

Brand	Fluidmaster
Model	PerforMAX 400CAR3
Category	Control Unit
Language	English