Fluke 373 User Manual

Clamp Meter
Safety Information
3
• Remove the test leads from the Meter before the battery door is opened.
• Examine the test leads for damaged insulation or exposed metal. Check test lead
continuity. Replace damaged test leads before using the Meter.
• Do not use the Meter if it operates incorrectly. Protection can be compromised.
When in doubt, have the Meter serviced.
• Do not use the Meter around explosive gas, vapor or in damp or wet
environments.
• When measuring, keep fingers behind the Tactile Barrier. See "The Meter" .
• Use only type AA batteries, properly installed in the Meter case, to power the
Meter.
• To avoid false readings that can lead to electrical shock and injury, replace the
batteries as soon as the low battery indicator () appears.
• When servicing the Meter, use only specified replacement parts.
• Have the Meter serviced only by qualified service personnel.
• Be careful around voltages > 30 V ac rms, 42 V ac peak, or 60 V dc. Such
voltages pose a shock hazard.
• Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
• When using the probes, keep fingers behind the finger guards on the probes.

Fluke 373 Specifications

General

Operating altitude	0 - 3000 m
Non-operating altitude	0 - 12000 m
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	0 - 90 %
Product color	Black, Orange
Ergonomic design	Yes
Continuity	30 Ω
DC voltage	600 V
Resistance (max)	6000 Ω
Resistance (min)	600 Ω
Measuring category	-
DC voltage resolution (min)	0.1 V
AC current maximum resolution (probe)	600 A
Battery type	AA
Battery technology	Alkaline
Number of batteries supported	2

Weight and Dimensions

Depth	85 mm
Width	232 mm
Height	45 mm
Weight	370 g