To Next PageTo Next Page
Need help?Do you have a question about the Fluke 377 and is the answer not in the manual?
General| Category | Clamp Meter |
|---|---|
| True-RMS | Yes |
| Voltage AC/DC | 1000 V |
| Resistance | 60 kΩ |
| Display Type | LCD |
| AC Current | 1000 A |
| DC Current | 500 A |
| Frequency | 5 Hz to 500 Hz |
| Frequency Range | 5 Hz to 500 Hz |
| Safety Rating | CAT IV 600 V |
| Wireless Connectivity | Fluke Connect |
| Battery Type | 2 x AA |
Explains Field Sense, L1-L2-L3 measurement, and the Fluke Connect system.
Information regarding radio frequency data and compliance declarations.
Covers warnings, cautions, and steps for installing batteries safely.
Details the buttons, display, and key features of the clamp meter.
Explains the symbols and indicators shown on the clamp meter display.
Automatically powers off after 20 minutes of inactivity. Can be disabled.
Improves display readability in dim light. Has manual and auto-off features.
Configure settings like beeper, auto backlight, auto power shutoff, and PQ Level.
Access to check LCD segments, firmware version, battery status, and calibration info.
Alerts user to hazardous voltage levels (±30V or overload) on the display.
Steps for measuring AC current, voltage, and frequency using Field Sense.
Procedure for sequential line-to-ground and line-to-line voltage measurements in three-phase systems.
Procedure for measuring AC/DC voltage using test leads and terminals.
Steps for measuring resistance and continuity, including beeper behavior.
Steps for measuring capacitance, including safety notes and error indications.
Procedure for measuring DC current using the clamp jaw.
Instructions for connecting and using the flexible current probe for measurements.
Captures and holds the display reading, includes periodic beeps and voltage alerts.
Captures minimum, maximum, and average readings; beeps on new high/low values.
Captures surge current spikes from devices upon power-on.
Enables data logging via Fluke Connect app; logging interval set in app.
Procedure to find the clamp's firmware version via maintenance mode.
Covers routine maintenance, cleaning case, and environmental disposal.
Details recommended calibration intervals and authorized service centers.
