Fluke 714B - Step and Ramp Modes; Auto Storage of Settings

714B
Users Manual
22
Step and Ramp Modes
The Product allows you to set Step and Ramp modes for
easier check of points within the linear range in Source
mode.
To set the Step or Ramp mode:
1. Push .
2. Use  and  to select Step mode or Ramp mode.
The  or  icon shows on the Product display
accordingly.
Note
This function is only available when Source
mode is selected.
Auto Storage of Settings
The Product automatically stores the latest settings,
including the temperature unit, the linear range of mA
converting to temperature, and sensor type.
Every time you turn on the Product, it automatically
applies the last settings.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com