Fluke 719 Series - User Manual

August 2008
© 2008 Fluke Corporation. All rights reserved. Specifications are subject to change without notice.
All product names are trademarks of their respective companies.
719 Series
Pressure Calibrator with Electric Pump
Users Manual

Fluke 719 Series Specifications

General

Accuracy	0.025% of full scale
Current Measurement	0 to 24 mA
Display	LCD
Pressure Media	Non-corrosive gases
Pressure Units	psi, bar, kPa
Resolution	1 µA
Loop Power	24V DC
Operating Temperature	-10 °C to 55 °C
Storage Temperature	-20 °C to 60 °C
Weight	0.65 kg

Summary

Safety Information

Getting Acquainted with the Calibrator

Switch Test

Switch Test Steps

Zeroing with Absolute Pressure Modules

Calibrating a P;I Transmitter

Using the Internal Pump

Percent Error Setup

In Case of Difficulty

Replacing the Batteries

Pump Valve Assembly Cleaning Instructions

Using an External Pump

External Fluke Pressure Module Compatibility

Supplying Loop Power

mA Modes

Sourcing 4 to 20 mA

Simulating a 4 to 20 mA Transmitter

Specifications

Pressure Sensor Input Specifications

Specifications for the built-in pressure sensor, including range, accuracy, and non-destructive pressure.

DC mA Measure and Source Specifications

Specifications detailing the calibrator's DC mA measurement and sourcing accuracy and resolution.

Pressure Module Input Specifications

Loop Supply Specification

Pressure Source Specifications

General Specifications

Contacting Fluke