EasyManuals Logo

Fluke 719 Series User Manual

Fluke 719 Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
1
Introduction
The 719 30G and 100G Series Pressure Calibrators (the
Calibrator) perform the following functions:
Calibrate P/I (pressure to current) transmitters
Calibrate I/P (current to pressure) devices
Identify the set, reset and deadband of of pressure
switches
Measure pressure via a 1/8-in. NPT pressure fitting
and an internal pressure sensor or via a Fluke 700
Series Pressure Module
Source pressure via electric pump
Measure, source, and simulate current up to 24 mA
Simultaneously displays pressure and current
Supply loop voltage
Calculate mA percentage in Percent Mode
Calculate mA error % in Percent Error Mode
Switch between pressure/vacuum control
The Calibrator features:
Precision air bleed for fine control
Fine vernier adjustment for the pump
A serviceable electric pump
Pressure limit settings
HART resistor mode
The Calibrator ships with:
holster
two installed 9 V alkaline batteries
TL75 test leads
AC70A alligator clips
hose kit
Product Overview Manual
CD-ROM (Users Manual)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke 719 Series and is the answer not in the manual?

Fluke 719 Series Specifications

General IconGeneral
Accuracy0.025% of full scale
Current Measurement0 to 24 mA
DisplayLCD
Pressure MediaNon-corrosive gases
Pressure Unitspsi, bar, kPa
Resolution1 µA
Loop Power24V DC
Operating Temperature-10 °C to 55 °C
Storage Temperature-20 °C to 60 °C
Weight0.65 kg

Related product manuals