753/754
Getting Started
10
Operation Features
Input and Output Jacks
Figure 2 shows the input and output jacks and connectors. Table 3 explains their use.
Table 3. Input/Output Jacks and Connectors
No. Name Description
A HART jack (754 only) Connects the Product to HART devices.
B Pressure module connector Connects the Product to a pressure module.
C TC input/output
Jack to measure or simulate thermocouples. This jack accepts a
miniature polarized thermocouple plug with flat, in-line blades spaced
7.9 mm (0.312 in) center to center.
D,E wMEASURE V jacks
Input jacks to measure voltage, frequency, or three- or four-wire RTDs
(Resistance Temperature Detectors).
F,G
wSOURCE mA, MEASURE
mA Ω RTD jacks
Jacks to source or measure current, measure resistance and RTDs, and
supply loop power.
H,I wSOURCE V Ω RTD jacks
Output jacks to source voltage, resistance, frequency, and to simulate
RTDs.
J Battery Charger jack
Jack for the battery charger/universal power supply (referred to as the
battery charger throughout this manual). Use the battery charger for
bench-top applications where ac line power is available.
K USB port (Type 2) Connects the Product to a USB port on a PC.
To Next Page
Loading...
