Fluke 80i-110s Instructions

PN 4862926 October 2005, Rev. 1, 1/17
©2005-2017 Fluke Corporation.
All rights reserved. Specifications are
subject to change without notification.
All product names are trademarks of their
respective companies.
80i-110s
AC/DC Current Probe
Instructions
Introduction
The Fluke 80i-110s (the Probe or Product) is a clamp-on AC/DC Current
Probe that reproduces current waveforms found in commercial and industrial
power distribution systems. The Probe performance is optimized for accurate
reproduction of currents at line frequency and up to the 50
th
harmonic
waveform. The 80i-110s is also compatible with any instrument capable of
millivolt measurements.
The Probe provides these benefits:
• Accurate AC, DC, and AC+DC current measurements for Electrical,
Electronic, and Automotive applications.
• Shielded for high-noise immunity around electronic motor drives and
ignition systems.
• Wide measurement range from 50 mA to 100 A, useful to 10 mA.
• Jaw shaped for easy access to cramped spaces.
• Tactile barrier (see Figure 1, item
).
• Safety-designed 600 V insuIated BNC - compatible with Fluke
ScopeMeter
®
test tools, Power Harmonic analyzers, and
oscilloscopes.
• Selectable output of 10 millivolts/1 amp for the 100 A range, and
100 mV/1 A for the 10 A range.
Figure 1. 80i-110s AC/DC Current Probe
1
80i-110s.book Page 1 Monday, December 5, 2016 12:12 PM

Fluke 80i-110s Specifications

General

Interface	Banana plugs
Cord length	1.6 m
Connector(s)	BNC
Product type	Current clamp
Product color	Black
Rated voltage	600 V
Maximum current	100 A
Measurement category supported	CAT II, CAT III
Storage temperature (T-T)	-30 - 70 °C
Maximum operating altitude	2000 m
Operating temperature (T-T)	0 - 50 °C
Quantity per pack	1 pc(s)

Weight and Dimensions

Length	231 mm
Weight	330 g