To Next PageTo Next Page
Need help?Do you have a question about the Fluke 805 FC and is the answer not in the manual?
General| Built-in display | Yes |
|---|---|
| Control type | Button |
| Signal-to-Noise Ratio (SNR) | 80 dB |
| Temperature measurement range | -20 - 200 °C |
| Temperature measurement units | F, °C |
| Temperature measurement accuracy | 2 °C |
| Infrared thermometer focal length | 3.8 cm |
| International Protection (IP) code | IP54 |
| Battery type | AA |
| Number of batteries supported | 2 |
| Cables included | USB |
| Operating altitude | 0 - 3048 m |
| Storage temperature (T-T) | -30 - 80 °C |
| Operating temperature (T-T) | -20 - 50 °C |
| Operating relative humidity (H-H) | 10 - 95 % |
| Bias current | 5 mA |
| Bias voltage | 20 - 22 V |
| Severity levels | Good, Satisfactory, Unacceptable, Unsatisfactory |
| Low frequency range | 10 - 1000 Hz |
| High frequency range | 4000 - 20000 Hz |
| USB 2.0 ports quantity | 1 |
Weight and Dimensions| Depth | 58 mm |
|---|---|
| Width | 71 mm |
| Height | 241 mm |
| Weight | 400 g |
Unpack and inspect the Meter, storage case, USB cable, quick reference guide, belt holster, and batteries.
Store the Meter in its supplied storage case when not in use for protection.
Install included AA lithium non-rechargeable batteries before first use. Alkaline batteries are not recommended.
Describes general operation and menu navigation using buttons like Setup, Measure, Save, Enter.
Explains how to change Meter configuration via the Setup menu, including Units, Time, Date, etc.
Explains the four severity levels: good, satisfactory, unsatisfactory, and unacceptable.
