Need help?Do you have a question about the Fluke 805 and is the answer not in the manual?
General| Frequency Range | 10 Hz to 1 kHz |
|---|---|
| Connectivity | USB |
| Operating Temperature | -10 °C to 50 °C |
| Storage Temperature | -20 °C to 60 °C |
| Display | LCD with backlight |
| Memory | Up to 3, 500 measurements |
| Accuracy | +/- 5% of reading |
| Battery Type | AA (2) |
| Vibration Measurement Range | 0.01 g to 50 g (0.1 m/s² to 500 m/s²) |
Provides phone numbers and website for Fluke support and service.
Details electrical, fire, personal injury, and equipment damage risks.
Lists and describes the various symbols used on the Meter and in the manual.
Lists the accessories available for the 805 Vibration Meter.
Covers sensitivity, range, resolution, and accuracy for the sensor and temperature.
Specific accuracy details for temperature measurements at different ranges.
Details frequency ranges, limits, battery, and operating/storage conditions.
Lists relevant standards and compliance information for EMI/RFI.
Includes unboxing, storage advice, and initial battery setup.
Identifies all buttons, ports, and sensors on the Meter.
Explains the meaning of different LED colors and states during measurement.
Steps for turning the Meter on and off, including shutdown methods.
Explains menu navigation and accessing device settings.
How to adjust units for acceleration, velocity, and displacement.
Steps to configure time (12/24 hr) and date formats.
Adjusting date values, backlight timeout, and display language.
Viewing device details and reconfiguring language.
Configuring battery type and emissivity for measurements.
Covers advanced emissivity settings, power saving, flashlight use, and connector types.
Detailed steps for connecting and configuring an external sensor.
Instructions for using headphones to listen to machine sounds.
How to connect to a PC via USB for data transfer and firmware.
Overview of available measurements and best practices for accuracy.
Explains high-frequency measurement and fast measurement procedures.
How to interpret overall vibration using the on-screen severity scale.
Lists predefined machine types for accurate measurements.
Steps to choose a machine category and set RPM for severity scales.
Explains what a setup is and its benefits for frequent measurements.
Step-by-step guide to defining test parameters for a machine.
How to name a setup for easy identification.
Detailed steps for adding sub-identifiers to existing setups.
Overview of saving options, memory, and the auto-save function.
How to save a measurement to a previously created setup.
How to save measurements to the active setup or create a new one.
Steps for naming new setups and adding second level IDs.
Steps to access and review saved measurement setups.
Overview of accessing saved IDs, data, and memory limitations.
How to display all recorded measurements and remove them.
How to browse and select saved setups.
Detailed steps to modify key parameters within a setup.
How to erase all stored data from the Meter.
How to interpret readings and use the severity scale.
General guidelines for machine vibration on non-rotating parts.
Details standards for industrial machines and pumps.
Steps to transfer data and open files in the trending template.
How to configure and generate graphs from exported data.
Instructions for cleaning the sensor and case.
Step-by-step guide to replace the AA batteries.
Instructions for downloading and installing firmware updates.
Lists common problems, causes, and corrective actions for the Meter.
To Next Page
