Vibration Meter
Symbols
3
Symbols
Table 1 is a list of symbols on the Meter and in this
manual.
Table 1. Symbols
Symbol Description
W Important information. See manual.
X Hazardous voltage.
P
Conforms to requirements of European Union
and European Free Trade Association.
Conforms to relevant Australian standards.
~
This product complies with the WEEE Directive
(2002/96/EC) marking requirements. The affixed
label indicates that you must not discard this
electrical/electronic product in domestic
household waste. Product Category: With
reference to the equipment types in the WEEE
Directive Annex I, this product is classed as
category 9 "Monitoring and Control
Instrumentation” product. Do not dispose of this
product as unsorted municipal waste. Go to
Fluke’s website for recycling information.
M Battery or battery compartment.
Low battery when shown on display.
Ã
Conforms to relevant South Korean EMC
standards.
Accessories
Table 2 is a list of the accessories available for the Meter.
Table 2. Accessories
Description PN
Belt Holster 4106625
Storage/Shipping Case 4094432
Battery Door 4059351
USB Cable 3563901
Specifications
Sensor
Sensitivity (typical) .............................. 100 mV / g ±10 %
Measurement Range .......................... 0.01 g to 50 g
Frequency Range ............................... 10 Hz to 1,000 Hz
and 4,000 Hz to 20,000 Hz
Resolution ........................................... 0.01 g
Accuracy (typical) ................................ At 100 Hz: ±5 % of measured value
Amplitude Units
Acceleration ................................ g, m/sec
2
Velocity ....................................... in/sec, mm/sec
Displacement .............................. mils, μm
Infrared Thermometer
Temperature Measurement
Range ................................................. -20 °C to 200 °C (-4 °F to 392 °F)
To Next Page
Loading...
