Vibration Meter
About Measurements
29
How to Recall a Setup for Measurements
You can recall a Setup file from memory for frequent
measurements done on the same machine. A Setup file
saves time when the parameter selection is already done
and stored to memory.
To recall a Setup from memory:
1. Push to open the MEMORY screen.
gqi72.bmp
2. Push and to highlight View Setups.
3. Push to opens the VIEW SETUPS
screen with three sorting options:
• by Name: shows a list of machine setups by
machine ID in alphabetical sequence.
• by Category: shows a list of machine setups
by Machine Category in alphabetical
sequence.
• Last Used: shows the last used machine ID.
gqi73.bmp
4. Push and to highlight an option.
5. Push to open the list of setups.
6. Push and to highlight a setup.
7. Push to open the setup record.
8. Push .
Note
Push before you apply the Meter to the test
surface.
9. Push Meter onto test surface until green LED turns
on.
10. Wait until the green LED turns off.
To Next Page
Loading...
