Vibration Meter
Before You Start
7
Measurement Status LEDs
The Meter has a status light for visual feedback about the
measurement. Green and red LEDs show the
measurement status and that a good measurement has
been taken. Table 4 is a list of the status as the LED
changes color.
Table 4. LED Status
90˚
SETUP
MEMORY
SAVE
MEASURE
ENTER
BEARING
TESTER
805
SETUP
MEMORY
SAVE
MEASURE
ENTER
BEARING
TESTER
805
SETUP
MEMORY
SAVE
MEASURE
ENTER
BEARING
TESTER
805
SETUP
MEMORY
SAVE
MEASURE
ENTER
BEARING
TESTER
805
gqi07.eps
Status Description
Green Off
Push . Meter is ready for data
measurement.
Green On
Push the sensor tip onto the test surface,
on solid metal, as close as possible to the
bearing. Apply the compression force until
green LED is off.
Green Off Data measurement is complete.
Red On
Error, insufficient force or time duration, no
data measurement.
To Next Page
Loading...
